Difference between revisions of "PS1 Powerstand / Daisy Chain"

Revision as of 10:31, 2 May 2007

L1 Model I This information is applicable to the L1 Model I

Run your microphone into the first L1™ PS1 Powerstand (let's say - Channel 1).
In the Channel 1 section run an XLR cable from the Channel 1 Line Out
At the other end of the cable connect a Pad. The people-at-Bose usually recommend a -20 dBu pad. Some owners have reported success with a -10 dBu pad.
Connect the Pad to the second PS1 Power Stand (Classic) / Model I Channel 1 or 2.
On the first PS1 Power Stand (Classic) / Model I, set the input trim appropriately.
Choose the best preset for your microphone.
On the second PS1 Power Stand (Classic) / Model I, the input trim should be similar to what you set on the first one, but check the trim o/l light for a solid green light (occasional red flickers are okay).
On the second PS1 Power Stand (Classic) / Model I, use the same preset as you used for the first one.

Arrows indicate the direction the signal is flowing.

Position the two L1 s at least 20 feet apart if possible to avoid the possibility of odd phase effects in the audience. More detail: Phase Cancellation
Close up view of the Input Panel

In this example, we are using Channel 2 so that you leave Channel 1 available for another input like a vocal.

You can

Run your input into the first L1™ PS1 Powerstand (let's say - Channel 2).
In Channel 2 section run an XLR cable from the Channel 2 Line Out
At the other end of the cable connect a Pad. The people-at-Bose usually recommend a -20 dBu pad. Some owners have reported success with a -10 dBu pad.
Connect the Pad to the second PS1 Power Stand (Classic) / Model I Channel 2.
On the first PS1 Power Stand (Classic) / Model I, set the input trim appropriately.
Choose the best preset for your microphone.
On the second PS1 Power Stand (Classic) / Model I, the input trim should be similar to what you set on the first one, but check the trim o/l light for a solid green light (occasional red flickers are okay).
On the second PS1 Power Stand (Classic) / Model I, use the same preset as you used for the first one.
For prerecored music or tracks or keyboards you want B1 Bass Modules as close together as possible, and the L1™s close together -or- at least 20 feet apart.

Revision as of 07:44, 22 January 2007 (view source) ST (talk \| contribs) m (formatting) ← Older edit		Revision as of 10:31, 2 May 2007 (view source) ST (talk \| contribs) m ({{Model I icon}}{{Classic icon}}) Newer edit →
Line 1:		Line 1:
		+	{{Model I icon}}{{Classic icon}}
	<table><tr><td>__TOC__</td><td>On the relatively rare occasion where you might need to connect the output from one {{PS1}} to another {{PS1}}.		<table><tr><td>__TOC__</td><td>On the relatively rare occasion where you might need to connect the output from one {{PS1}} to another {{PS1}}.