View source for Rubber Feet for L1®

<html>
<div style="max-width:800px">
I removed a nearly new foot from a Model II. The measurements are as follows:<br>Diameter 1-3/16" X height 3/8" (30mm X 9.6mm)<br>

The maximum height of 3/8" (9.6mm) for the feet is important for stability;  <i>it is not recommended to use thicker feet because the ends of the fold out legs would be raised off of the floor</i><br><br>
The recesses where the feet are installed will not accept a larger diameter than the original feet but 1" (25.4mm) should work fine.<br>

I did a bit of research for you for some possible replacement feet:<ul>
<li>
<a href="http://www.penn-elcom.com/default.asp?PN=F1690%20-%20F1697&amp;LG=ENG" target="_blank">Penn Elcom F1690</a>
</li>
<li> 

<a href="https://www.digikey.ca/product-detail/en/keystone-electronics/723/36-723-ND/61962" target="_blank">Keystone Electronics 723 DigiKey</a> </li>
<li> 

<a href="http://www.mojotone.com/Cabinets_x/Feet_x/Mojotone-Rubber-Feet-1Wx3-8H-25-4x9-5mm" target="_blank">MojoTone Rubber Feet, 25.4X9.5mm</a></li>
</ul> 

This type of feet are commonly used under guitar amp cabinets, it's a matter of finding some of the correct height and of a diameter that will fit. These need to have a steel washer for the mounting screw.<br>
This should help you find suitable replacement feet.
<br>
Mark
</div>
</html>

Source: Le5 [http://bose.infopop.cc/eve/forums/a/tpc/f/7521050644/m/3780003386?r=5510013386#5510013386 Rubber Feet for L1®]

----
[[Category:Model II]]
[[Category:Model 1S]]