PS1 Powerstand / Daisy Chain: Difference between revisions

Revision as of 20:18, 19 November 2006

On the relatively rare occasion where you might need to connect the output from one PS1 Power Stand (Classic) / Model I to another PS1 Power Stand (Classic) / Model I:

You can

Run your mic into the first L1™ PS1 Powerstand (let's say - Channel 1).
In Channel 1 insert an XLR cable from the Channel 1 Line Out
At the other end of the cable connect a Pad. The people-at-Bose usually recommend a -20 dBu pad, but some have reported success with -10 dBu
Connect the Pad to the second PS1 Power Stand (Classic) / Model I Channel 1 or 2.
On the first PS1 Power Stand (Classic) / Model I, set the input trim appropriately.
Choose the best preset for your microphone.
On the second PS1 Power Stand (Classic) / Model I, the input trim should be similar to what you set on the first one.
On the second PS1 Power Stand (Classic) / Model I, use the same preset as you used for the first one.

Arrows indicate the direction the signal is flowing.

Position the two L1 s at least 20 feet apart to avoid the possibility of odd phase effects in the audience. More detail: Phase Cancellation
Close up view of the Input Panel

@@ Line 15: / Line 15: @@
 Arrows indicate the direction the signal is flowing.
-* To avoid the possibility of odd phase effects in the audience, you want to have the two L1™s at least 20 feet apart. More detail: [[Phase Cancellation]]
+* Position the two {{L1}}s '''at least 20 feet apart''' to avoid the possibility of odd phase effects in the audience. More detail: [[Phase Cancellation]]
 * [[PS1 Powerstand Connections/Interactive|Close up view of the Input Panel]]