Difference between revisions of "T1 ToneMatch® Audio Engine / Single Input to Two Channels"
m (ST moved page T1 ToneMatch® Audio Engine / Single Input to Two Channels to T1 ToneMatch® Audio Engine / Single Input to Two Channels) |
|||
(One intermediate revision by the same user not shown) | |||
Line 20: | Line 20: | ||
[[Image:GeorgeLCable.jpg]] | [[Image:GeorgeLCable.jpg]] | ||
− | + | The live discussion continues [http://bose.infopop.cc/eve/forums/a/tpc/f/7521050644/m/95710414 in the Message Board]. | |
---- | ---- | ||
[[Category:T1]] | [[Category:T1]] | ||
[[Category:T1 Tips]] | [[Category:T1 Tips]] |
Latest revision as of 05:03, 26 March 2017
If you are not using all the Channels on your T1 ToneMatch® Audio Engine you can send a single input to more than one Channel. In the picture below I have my
- Vocal microphone going to Channel 1 and then Channel 3.
- Guitar going to Channel 2 and then Channel 4
Let's follow the signal paths (from right to left in the picture).
Blue: Microphone into Channel 1. The Preamp Out of Channel 1 then goes to Channel 3.
Yellow: Guitar into Channel 2. The Preamp Out of Channel 2 then goes to Channel 4.
I also run a my PorchBoard Bass into Channel 5. There is no conflict because the PorchBoard's fundamental frequency is 30 Hz. That is so low that there isn't much I can do with the Presets or EQ for the Guitar that affects it.
Here is a picture of one of the cables under the blue and yellow lines in the picture above.
The live discussion continues in the Message Board.