Difference between revisions of "S1 Pro to L1 Model I"

From Bose Portable PA Encyclopedia
Jump to: navigation, search
(Created article)
 
m (Text replacement - "Category:S1" to "Category:S1 Pro")
 
(One intermediate revision by the same user not shown)
Line 7: Line 7:
 
Connect {{S1}} to {{Model I}}
 
Connect {{S1}} to {{Model I}}
  
You can connect to the S1 Pro system as you would when using it alone. Then run a cable from the S1 Pro Line Out to any of the 1/4" inputs on the L1 Model I. You can use an ordinary Tip-Sleeve instrument cable.
+
You can connect to the S1 Pro system as you would when using it alone. Then run a cable from the S1 Pro Line Out
 +
 
 +
{{S1 Pro Line Out}}
 +
 
 +
 
 +
to any of the 1/4" inputs on the L1 Model I. You can use an ordinary Tip-Sleeve instrument cable.
 +
 
 +
[[File:L1 Model I 14 inputs.jpg]]
  
 
If you use the L1 Model I inputs on channels 1 or 2, set the Preset to 00. Set the input trim so that when you are running the S1 Pro at the loudest you will perform, the L1 Model I Signal/OL lights are solid green. Occasional red flickers are okay.
 
If you use the L1 Model I inputs on channels 1 or 2, set the Preset to 00. Set the input trim so that when you are running the S1 Pro at the loudest you will perform, the L1 Model I Signal/OL lights are solid green. Occasional red flickers are okay.
  
 +
[[File:SignalOLLED.png]]
  
  
Line 22: Line 30:
  
 
     [[Category:How To]]
 
     [[Category:How To]]
     [[Category:S1]]
+
     [[Category:S1 Pro]]
 
     [[Category:Model I]]
 
     [[Category:Model I]]
 
     [[Category:Connections]]
 
     [[Category:Connections]]
  
 
}}
 
}}

Latest revision as of 22:20, 16 November 2019

If you want to use your S1 Pro System as a monitor and use an L1 Model I as the Front of House system you can connect your microphone and instrument to the S1 Pro System and connect the S1 Pro System to the L1 Model I


How To

Connect S1 Pro System to L1 Model I

You can connect to the S1 Pro system as you would when using it alone. Then run a cable from the S1 Pro Line Out

The S1 Pro System Line Out is post Volume, Tone, and ToneMatch presets on channels 1 and 2. It also includes the post volume signal from channel 3.

S1 Pro Line Out


to any of the 1/4" inputs on the L1 Model I. You can use an ordinary Tip-Sleeve instrument cable.

L1 Model I 14 inputs.jpg

If you use the L1 Model I inputs on channels 1 or 2, set the Preset to 00. Set the input trim so that when you are running the S1 Pro at the loudest you will perform, the L1 Model I Signal/OL lights are solid green. Occasional red flickers are okay.

SignalOLLED.png

Additional Information

Note: All the 1/4" inputs on the L1 Model I are unbalanced. That means, there's no need or advantage to using a balanced Tip-Ring-Sleeve cable. Also, if you use a 1/4" Tip-Ring-Sleeve to XLR cable into channels 1 or 2, you may find it difficult to do the gain staging because the signal from the S1 Pro may be too hot for the XLR inputs.